|Date Added:||28 December 2012|
|File Size:||65.69 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
The parameter control is a bit mask that specifies various operations. Also the api buffer must stay allocated and the contents of unsent data must not be modified.
SPI on Kinetis K60
Not l60 event is necessarily generated by the driver. The parameter data specifies the data buffer. The parameter arg provides depending on the parameter control additional information, for example the Bus Speed. Content Data Structures Typedefs Functions. The only issue I got was with the capacitivi touch sense pads.
SPI Master connected to a single slave. Structure with information about the status of the SPI. How do you power the tower? Occurs also in master mode when driver cannot transfer data fast enough.
Some hardware will leave the line activated until the SPI stays master. Slave Select when Slave. Start receiving data from SPI Interface.
Each instance of a SPI interface provides such an access structure. Set the Slave Select mode for the master to Not used.
Set the Slave Select mode for the master to Software controlled. Note Some devices require that the SS signal is strictly defined regarding transfers. Access structure of the SPI Driver.
Tower Geeks | NXP Community
Software controls if the slave is responding or not by default it is not responding. The parameter num specifies the number of items to receive. For example, when a single master and slave are connected in the system then the Slave Select line is not needed.
SPI Master connected to 3 slaves. It is called when the middleware component stops operation and releases wpi software resources used by the interface.
How to configure K60 SPI PCSIS
Negative values are Status Error Codes. The default is 0which connects a middleware to the first instance of a driver.
The function is called when the middleware component starts operation and performs kk60 following: Master does not drive or monitor the SS line. Clock Polarity 0, Clock Phase 0. Slave Select is configured as input and hardware only monitors the line.
Occurs also in master mode.
The function is non-blocking and returns as soon as the driver has started the operation driver typically configures DMA or the interrupt system for continuous transfer. Set the Slave Select mode for the master to Hardware controlled Output. Miscellaneous controls cannot be combined. By default, the line it is not active highand is not affected by transfer- send- or receive functions.
When I try to compile this demo, a problem occur: